TruXedo Lo Pro Tonneau Cover 530601

Perfect fit, easy install.

Instructions and pictures stunk, took a while to figure it out, also needed a heads up on the torque bit.

This product was very easy to install and only took about 30 minutes. I would recommend it as an economical fast and friendly solution.

Very happy with cover. Was installed in under an hour. Looks great.

Worked fine.

Installed on a 2019 Honda Ridge line... Good looking cover. Easy to install. Although the installation sheet didn't call for it, I bought some foam tape for the bulkhead to assure no leaking would occur there. Quality seems fine... need more time installed to tell for sure. I haven't put it through a leak test yet, but see no reason to suspect there will be a problem with leaking.I can crawl into the closed bed and can not spot any daylight anywhere from the seams. But because of the following discussed Honda Ridgeline issue, I can only give this product a total rating of 3 stars Please note... this is something that should be of interest to Honda Ridge line owners. Once this bed topper is installed, the rails prevent you from completely opening your built in Honda trunk. With the bed cover rolled back out of the way, you can perhaps open the Honda trunk door only 25-30% of the way and then you will need to cut a prop to hold the trunk cover open while you load/unload. I was kinda surprised that this characteristic wasn't mentioned. Had I known this issue up front I would have bought a trifold bed cover instead.

The product was as described but a little expensive.

Difficult to install!

Excellent product. I appreciated the extra instructions specifically for installing on a Honda Ridgeline.

Sold my 2011 Tacoma to a friend who commented how great 10 year old Lo Pro looked. Had to get a new one for my Honda Ridgeline. Easy install, same quality, sure this one will look great in 10 years as well.

Installation was not very difficult and took just over an hour, The only issue is that the rails can not be made level because the top of the bracket where the rail mounts to is not 90 degrees to the part of the bracket that mounts to the truck bed. Have had several email exchanges with TruXedo and they claim that the bracket is made at 95 degrees by design. They told me to have a second person help with the installation and push the rail assembly down and towards the bed rail which I did but to no avail. It is a little better but still not level. The only way to do this right would be to modify the bracket which I may end up doing when time permits.

I have only had it a week but so far so good.

Very good product, installation was quick and easy. The only complaint is that it doesn’t seal totally.

Very good quality cover. The instructions were easy to follow.

Great product! Well designed, quick, simple install. Easy on & off if you need to remove. Arrived with shipping damage, AAG contacted Truxedo and replacement parts were sent out the same day. Great customer service from both companies. Looks like it will last 15+ years like the one still going strong on my 04 Tundra that I just sold.

Easy to install, clear directions, and it looks beautiful on my truck.

This the second Lo Pro I have owned. This had brackets instead of clamps. Install went OK. I am still figuring out the water proofing!

This is a very nice product. I installed in on a 2019 Honda Ridgeline in about a half hour. It would have been less if I wouldn't have broke a screw and had to hunt up another one in the shop. Even though I gave it all 5 stars, there are a couple improvements that TruXedo could make. The side rails install inside the bed but they really could wrap around the edge. That would make installing even easier and it would be a little more waterproof. On the Ridgeline there are no tie-down holes to worry about. The other thing is the instructions. The general instructions are in the box and easy to find, but the actual instructions for the Ridgeline are in the accessory box. The general instructions make no sense for the Ridgeline.

What an easy install! The special brackets for the Ridgeline fit perfectly, all holes lined up, and I didn't even need to adjust the tensioners. I would suggest looking at the Ridgeline instructions online, the color photos are much better than the little printout that comes in the clamps box. The only improvement I can thing of would be if a t-27 torx bit was included, would have saved me a trip to the hardware store for a dollar item. Oh, and it looks great. On my previous truck with a longer bed I had installed a trifold tonneau, found I had to take it totally off a lot when hauling large items, so with this truck I opted for a rollup and hopefully will never need to remove it.

Easy to install. Brackets fit well on my 17 Ridgeline. Only complain is I have to drop the tail gate to open. I would have preferred the latch to be on the right side.

Great product and custom fit! Very easy to install. This is my 3rd cover I've installed and I'm very pleased with the performance of the product.