WeatherTech TechLiner Truck Bed Mat

Bed mat fits great, thickness and surface is like the car mats. Contoured up around the bottom of the bed 2-3” as described. It’s ez to spot and wipe the bed for the Velcro tape which seems to hold well. The tailgate mat is better than I’d hoped for, using some of the tailgate bolts to hold the mat. Perfect fit. The plastic channel securing the top of the mat is a nice finish but catches slightly on the end of my tonneau cover. That may become a problem later.

Fits perfectly and looks great. I bought a used truck with a spray on bed liner that was rough from use. This bed mat went on over the existing liner and makes the bed look brand new.

Mat fits like a glove and easy to install. Longest wait was for mat to flatten itself out. After that it was a snap. Great product

Both items arrived rolled up in cardboard boxes which after removing them I layed them out in the sun to soften and flatten... the fit is perfect to the contours of the bed and tail gate, for the intents and purpose I need they should do just fine.

Fits good on two sides but the one side not so good.

The look of the product is fine, but the way it is installed needs a lot of updating. There are way too few Velcro strips holding it in place and I had to install about 30 feet of additional Velcro just to keep it in place correctly.

Tailgate and bed mat were exactly what i ordered and easy to install!

Great product I had bought one before for my 2014 chevy Silverado.

excellent product

Order arrived promptly. The mats are folded or rolled in the box for shipping. I laid them out on the floor inside with some weights on them to get them to flatten out and relax. The fit is very precise so you need to be careful aligning each item into position. Bought this as a set - bed cover and Tailgate cover. The Tailgate cover was more challenging to install. The included torx bit was perfect. Sliding the mat into the installation "clips" at the top of the tailgate was challenging - I ended up keeping the loosened part of the tailgate loose after I installed the clips and then sliding the cover into the clips. It was the only way I could make it work - then I tightened everything down. It was 30 degrees out so that may have made the items stiff. The bed cover relies on heavy-duty velcro pads that stick to the truck bed. Since it was so cold I could not stick those down (and it is not recommended) so I laid the cover in the bed again with some weights to hold it in place while it relaxed. It is staying in place well and looks great. I'll stick it down this later this month when it warms up to 50+ degrees.