Coverking Genuine CR Grade Neoprene Seat Covers

A little difficult to install in the back seats.

The fit is excellent. Installation is... interesting. Be prepared to sweat a lot and have sore hands afterwards, but the final product is well worth the pain and the money. These look better than my factory covers and are water resistant to the extreme. (2016 Ford F150) Here are before and after pictures for the front of my truck.

I bought the same covers for the front and loved them so much, I bought the back covers. I installed the bottoms no problem with the straps to go under the seats. When I got to the back I seen they sewed velcro around the entire back cover. It stuck to the sides good. The top and bottom another story. I took out the back seat of the truck since I wanted to get fitted tight all around. When I laid it on the table and went to fit it I found the velcro on the top and bottom of the back was useless. I couldn't get it to stick for nothing. I ended up taking a hole punch (into the velcro strips) and using wire ties to secure it to the metal straps on the back side to get it to fit on the top and bottom 100% tight all around. Looks awesome now but definitely could of made it easier if Cover King Sewed 6 straps to go around the back of the back seat.

Easy install utilized the bag that came with it over the seat and slipped the cover over that and pulled the bag out by pulling it once the cover was where I wanted it. No issues what so ever. Used a bag from home for the passenger side and followed the dame steps. I took extra time tucking and looking at the install prior to clipping. We cannot tell the difference, they look like they came from the factory. The 2014 fusion seat material is very poorly made. It shows all wear in a short time of owning it. This will protect and save dollars on repairs or replacement when selling. Glad I made the choice. There are videos for install on YouTube.

Wife is writing review as she installed (hubby has diabetic neuropathy and dexterity is not his friend). I installed coverking covers in my 2014 Hyundai Elantra and love them. So I ordered for the hubby's new F-150. There are installation videos of several models on the website, so check those out before you start the installation. The only video they did not have was for the middle seat of this supercab model. The drivers side had electric controls which make the install a little tricky but certainly not impossible. Installation recommends you remove the straps holding the back side of the manufacturer seat in order to install the seat covers. This was not possible with the drivers side as Ford had all the electrical plugs for the seat installed over the straps of the back side of the seat. With the wonderful plastic installation tool provided, I was able to feed the straps by hand in below the backside of the seat and put the cover in the fold without having to attempt to disconnect the electrical connections and take the straps off. I incurred the same issue with the passenger side. The middle seat of this model is not on any of the install videos. I had a bear of a time getting the headrest out (Ford problem, not coverking). The bottom seat you need to feed the flap in front of the plastic parts facing the rear seats and along the bottom securing with the velcro stitched in the cover. The back of this seat they did an incredible job of stitching tabs that fit into the plastic molding of the seat for a nice, tight fit. A video up on the site would be very beneficial to those who have an F-150 supercab. Once I figured out everything, it all fit like a glove. These covers look like the original seats and I anticipate they will last for years.

Love these covers so much I ordered a set for the back seat. Easy to install. Look great.